vertices, 3e new edges, and e new hexagonal faces. In the chapters below, the chamfers of the five Platonic solids are described in detail. Each is shown in an...
25 KB (1,272 words) - 01:55, 27 July 2024
A chamfer (/ˈʃæm.fər/ or /ˈtʃæm.fər/) is a transitional edge between two faces of an object. Sometimes defined as a form of bevel, it is often created...
7 KB (916 words) - 01:56, 27 July 2024
polytope to its birectified form. Uniform polyhedron Uniform 4-polytope Chamfer (geometry) Coxeter, H.S.M. Regular Polytopes, (3rd edition, 1973), Dover edition...
5 KB (236 words) - 19:03, 21 November 2022
Datum reference (category Geometry)
serves as a reference in defining the geometry of the object and (often) in measuring aspects of the actual geometry to assess how closely they match with...
6 KB (900 words) - 02:47, 7 September 2023
chamfer plane is a specialised plane used In woodworking for making chamfered edges. "Tools". swingleydev.com. Swingley, Christopher (2002). "Chamfer...
844 bytes (47 words) - 15:16, 31 October 2023
Conway polyhedron notation (category Elementary geometry)
In geometry and topology, Conway polyhedron notation, invented by John Horton Conway and promoted by George W. Hart, is used to describe polyhedra based...
46 KB (2,672 words) - 00:45, 19 March 2024
edges, and 42 faces: 30 hexagons and 12 pentagons. It is constructed as a chamfer (edge-truncation) of a regular dodecahedron. The pentagons are reduced...
10 KB (597 words) - 21:18, 11 November 2023
Planing (shaping) (section Workpiece geometry)
Before and after geometry...
3 KB (468 words) - 09:24, 15 June 2021
sterication cuts cells, faces, and edges. Edge-truncation is a beveling, or chamfer for polyhedra, similar to cantellation, but retaining the original vertices...
13 KB (1,045 words) - 03:19, 19 September 2023
in the application of the Hippodamus plan was that the blocks had 45º chamfers to allow better visibility. The development of the plan lasted almost a...
43 KB (5,754 words) - 13:53, 21 April 2024